Water Drainage; Electrical Connection - Electrolux EWP10742 User Manual

32 www.electrolux.com
The inlet hose must not be
lengthened. If it is too short and
you do not wish to move the tap,
you will have to purchase a new,
longer hose specially designed for
this type of use.

11.3 Water Drainage

The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink
using the plastic hose guide
supplied with the machine.
In this case, make sure the end
cannot come unhooked when the
machine is emptying.
This could be done by tying it to
the tap with a piece of string or
attaching it to the wall.
In a sink drain pipe branch. This
branch must be above the trap so
that the bend is at least 60 cm
above the ground.
Directly into a drain pipe at a
height of not less than 60 cm and
not more than 90 cm.
The end of the drain hose must
always be ventilated, i.e. the
inside diameter of the drain pipe
must be larger than the outside
diameter of the drain hose.
The drain hose must not be
kinked. Run it along the floor; only
the part near the drainage point
must be raised.
For the correct functioning of the
machine the drain hose must
remain hooked on the proper
support piece situated on the top
part of back side of the appliance.

11.4 Electrical Connection

This machine is designed to
operate on a 220-240 V,
single-phase, 50 Hz (60 Hz for
PHILIPPINES) supply.
"An incorrect power supply
may void your warranty."
Check that your domestic
electrical installation can take the
maximum load required (2.2 kW or
2.0 kW for PHILIPPINES), also
taking into account any other
appliances in use.
CAUTION!
Connect the machine to
an earthed socket outlet.
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the
above safety precaution.