Electrolux EWP10742 User Manual page 16

16 www.electrolux.com
5.2 Interruption Of A Program
- To pause press Start/ Pause. The
indicator will start flashing.
- Press the Start/Pause again. The
program will continue.
5.3 Changing A Program
Changing a running program is possible
only by resetting it.
1. Turn the program selector knob to the
position '
and to turn off the appliance.
2. Turn the program selector knob to the
new program position and set the new
option, then press 'Start/Pause'
touchpad again.
5.4 Changing The Options
It is possible to change only some option
after the program has started.
1. Press the touchpad Start/Pause.
The indicator will start flashing.
2. Change the options.
3. Press Start/Pause again. The program
will continue.
5.5 Opening The Door
While a program or the delay start is
operating, the appliance door is locked
and the display shows the indicator '
First set the machine to PAUSE by
pressing the "Start/Pause" touchpad.
Wait until the door lock indicator '
goes off, then the door can be opened.
If the door lock indicator '
disappear, this means that the machine
is already heating and the water level is
above the bottom edge of the door or
the drum is turning. In this case the door
CAN NOT be opened.
' to cancel the program
The appliance will not drain the
water.
' does not
If you can not open the door but you
need to open it you have to switch
the machine off by turn the program
selector knob to the position '
deactivate the appliance. After about
5 minutes the door can be opened.
CAUTION!
Pay attention to the water
level and water temperature.
5.6 At The End Of The Program
-
The appliance stops automatically.
-
The acoustic signal will operate.
-
The display will show '
models) or Washing End '
pilot lights come on (none-display
models).
-
The indicator of the Start/Pause
touchpad goes off.
-
The door lock indicator '
goes off.
-
Remove the laundry from the
appliance. Make sure that the
drum is empty.
- Keep the door ajar, to prevent
the mildew and odours.
-
Turn off the water tap.
5.7 When The Washing Program
Is Completed, But There Is
Water In The Drum
-
The drum turns regularly to prevent
'.
the creases in the laundry.
-
The door lock indicator '
on. The door stays locked.
'
You must drain the water to open
the door.
To drain the water:
1. Set the "Spin" or "Drain" program.
2. If necessary, decrease the spin
speed.
' to
' (display
'
'
' is