Scanning For Active Channels; Call Alert - Midland MXT400 Ownsers Manual

3. Press and hold the Scn/Mon button to enter Monitor mode.
▪
You will hear any activity on the current selected channel.
4. Rotate the Volume Knob to increase or decrease radio volume.
5. Once the radio volume has been adjusted to the desired level, press
and hold the Scn/Mon button to exit Monitor mode.

Scanning for Active Channels

Your MXT400 includes an "auto-scan" mode that continuously scans all 15
GMRS channels for activity.
To enter and exit "auto-scan" mode:
1. Be sure the radio is turned on (see Power On/Off)
2. Quickly press and release the Scn/Mon button to enter "auto-scan"
mode
▪
Your radio will rapidly scan through the 15 GMRS channels and will
pause on any active channel.
▪
"Auto-scan" will resume when there has been no activity on the
current channel for four seconds.
3. To transmit during "auto scan," press and hold the PTT button on the
microphone while the radio is paused on the desired channel.
▪
The radio will remain on the active channel for three seconds after
the PTT button is released.
4. To exit the "auto-scan" mode, quickly press and release the Scn/Mon
button.

Call Alert

Your radio can transmit a call alert for a fixed length of time.
To send a call alert
1. Press and release the CALL button.
▪
The TX indicator will enable while transmitting a call alert and a tone
can be heard on the speaker for confirmation.
midlandusa.com
Model MXT400
Page 16