Planet WNAP-6308 User Manual page 77

 Country Code
 Frequency (Channel)
 Site Survey
 Network Mode
 Extension Channel
 Distance
 ACK/CTS Timeout
 Network Name (SSID)
 WPS Choice
 Encryption Settings
 WPA Algorithms
 Key Renewal Interval
(Seconds)
 Pre-Shared Key
enter the descriptive names that you want to use.
Set your country code by clicking the "Set Country Code".
Set the channel you would like to use. The channel range will be
changed by selecting different domain.
Click "Site Survey" button to observe the signal of remote sites.
Select the operating channel width to WiFi 11gn (mixed), HT20 or
HT40MHz.
An extension channel is a secondary channel used to bond with the
primary channel to increase this range to 40MHz. Bonded channels
allow for greater bandwidth on the local network.
To decrease the chances of data retransmission at long distance, the
IEEE 802.11b/g/n Wireless Outdoor CPE can automatically adjust
proper ACK timeout value by specifying distance of the two nodes.
ACK/CTS Timeout settings are for long distance links. It is important
to tweak settings to achieve the optimal result based on requirement.
The device's default settings should be sufficient for most
applications.
The value is auto determined by distance between the radios, data
rate of average environment.
It is the wireless network name. The SSID can be 32 bytes long.
User can use the default SSID or change it.
The default SSID is WNAP-6308.
Enable it to use WPS associating with AP or Client device.
Select the encryption type that you would like to use.
Select the WPA Algorithms that you would like to use.
The key renewal time is the period of time that the AP uses the same
key before a new one is generated.
Data encryption and key are required for wireless authentication.
-67-
User Manual of WNAP-6308