Description Of The Rear Side Of The Camera - profiline TV7331 Installation Manual

7.1 Mounting the lens
The PROFILINE True Colour camera can be operated with both manual and auto-iris lenses. CS
Mount lenses can be attached directly. If you use a C Mount lens, first attach the spacer
contained in the delivery to the camera. Proceed as follows when installing the lens:
1. Screw the lens into the lens holder in an anticlockwise direction.
2. Connect the lens cable to the auto-shutter lens socket (for AI lenses only).
Note: Use a lens weighing less than 450g.
For heavier lenses, the lens and camera must be fitted with additional support.

8. 1 Description of the rear side of the camera

AC85V~ 265V
NC
GND NC TX RX
REMOTE
(1) Monitor output connector (MON OUT)
BNC output. This connector provides a composite signal 1Vp-p. Recommended connection for the
test monitor.
(2) Video output connector (VIDEO OUT)
BNC output. This connector is for connecting the camera video signal to the VIDEO IN connector
of, for example, the monitor (composite signal: 1Vp-p).
(3) Digital connector (GND I/O)
Not used in color version.
(4) Communication interface (REMOTE)
RS-232 interface for programming the color camera via PC software.
(5) Power supply (12V DC/24V AC) – TV7330
Power supply (230V AC) – TV7331
Connect to a corresponding power source. If you use a DC power supply, the polarity is
unimportant. If you use 230V AC, check national regulations.
34