Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for GTC TA300
Summary of Contents for GTC TA300
- Page 1 User’s Handbook TA300 Diesel EngineTachometer...
- Page 2 Exceeding the limits listed above when using this apparatus, or not observing the precautions listed above can expose you to physical injury and permanently damage your instrument and/or parts and components of the vehicle under test. “V Ready” and “GTC” are registered trademarks of General Technologies Corp. Page 2...
- Page 3 • When the instrument is ON, press momentarily the Power ON/OFF / Reset 3.2.1 LCD Display description button to reset the Maximum and Minimum values. Note: To extend battery life, the TA300 will automatically turn off after 3 minutes of being Low battery indicator Maximum reading (x10) idle (i.e.
- Page 4 Never touch the piezoelectric The TA300 allows the user to adjust the level of signal sensitivity it can detect, in order to sensor during a test. Wear insulating gloves when working around high volt- match a wide variety of fuel pressures and fuel lines characteristics.
- Page 5 50%. • For example, if the trigger level is set to 70%, the TA300 will register an engine cycle 4.2.1 Poor electrical contact when the signal level from the piezoelectric sensor reaches or exceeds 70% of the Please refer to ‘4.1 Using the piezoelectric sensor’...
- Page 6 4- Connect the new battery observing the polarity of the battery connectors. 5- Replace battery cover and rubber holster. 4- Press the Power On/Off / Reset button on the TA300 until the display turns on. If the display does not turn on, check the battery polarity and reinstall if necessary.
- Page 7 Part # TA300MN1005EN General Technologies Corp. #121 - 7350 72nd Street Tel.: (604) 952-6699 Delta, BC Fax: (604) 952-6690 Canada V4G 1H9 www.gtc.ca © 2010 General Technologies Corp. Printed in Canada...
Need help?
Do you have a question about the TA300 and is the answer not in the manual?
Questions and answers