Table of Contents
Advertisement
Installation before use
Do not store plastic, paper or clothing that may
burn or melt on top of the dryer during operation.
Do not dry articles containing rubber, plastic or similar
materials such as padded bras, tennis shoes,
galoshes, bath mats, rugs, bibs, baby pants, raincoat
plastic bags or pillows that may melt or burn. Some
rubber materials, when heated, can under certain
circumstances produce fire by spontaneous
combustion.
This product belongs to type I electronic products; please take note of safety warnings accordingly:
1.It is rule to use power with an earth connection which is buried in the earth and will not touch any
gas pipe or water pipe etc. Ensure that a separate earth connection is used..
2.Please use special socket which is according to National Standard and will carry 10A current. To
be safe, make any improvements according to the instructions above before connecting the dryer.
Please pay attention to use the dryer machine only if the materials of your clothes are approved for
placing in a clothes dryer. The clothing label may include one or more of the following symbols:
Dry
Normal
Line dry / hang to dry
Drip dry
Dry clean
Do not dry clean
The exhaust air must not be discharged into
a flue which is used for exhausting fumes
from appliances burning gas or other fuels.
The door can be opened only after the
programme of the drying machine is completed.
Do not open the door before the programme
finished to avoid the human skin from being
scalded by very hot steam or the hot dryer.
Not tumble dry normal
Do not dry
Dry flat
In the shade
Dry clean normal cycle
Dry clean normal cycle
with any solvent
petroleum solvent only
6
Simple installation
Simple installation
Step 1: Dryer should be placed in a ventilated area no
closer than 10cm from the wall. If placed in a room such
as a bathroom, it is suggested there are no obstacles
within 1.5m of the front of the dryer. Maintain ventilation
always.
Step 2:The horizontal adjustment: Tie a heavy object on a string on the
front and two sides of the dryer. Please refer this to below figure, and if
A=A', B=B', this means the dryer is placed horizontally. If not, use non-
flammable packing material under the dryer feet to level the dryer.
Notice:
If dryer is not horizontal (the lean angle
should be no more than 2'), the dryer may
become unbalanced or stop working .
Notice when installing:
• Do not install the dryer in the open air or where it may be damaged by rain;
• Do not place the back of dryer near curtain or anything blown by the wind;
• Do not place the dryer near gas or flammable materials.
Step 3:Regarding the fixing of flex tube (only to back vent):
• Connect one side of flex tube with spiral to the back
vent, then turn it gently clockwise until tight.
• The other end of flex tube should be extended outside,
please refer to the pictures below for correct examples.
>10cm
B
A
B'
A'
heavy object
7
Advertisement
Table of Contents
