Receives Ok, Does Not Amplify Transmit; Continuously Trips Fault Light; Relay Chatters Or Clicks Off And On; Technical Assistance - Mirage B 1018 G User Manual

Hide thumbs Also See for Mirage B 1018 G:

Table of Contents

6.4 RECEIVES OK, DOES NOT AMPLIFY TRANSMIT

Does your radio transmit OK without the amplifier removed and replaced with a barrel

connector? If not, see 1.3, 2.4, 4.4,

Is SWR okay, both with the amplifier in-line and out-of-line? See 3.5,4.6

Check transmitter power. Be sure to check the PEAK power, because some radios transmit a

pulse greatly exceeding the continuous power. If your radio has this problem, it is unsuitable for

any amplifier because it will eventually damage the amplifier's transistors. See sections

2.1,3.1,and 4.2

Check the SWR and reflected power. Look for bad cable connections. See sections 1.3, 2.4, 3.5,

and 4.6

RADIO and ANTENNA leads are reversed

Drive power is too low (under ½ watt)

Technical assistance is available Monday through Friday by calling 662-323-8287 between the

hours of 8:00 a.m. and 4:30 p.m. central time.

Please be sure you have check the obvious problems, and that you have the model number and

information about your radio and power meter available.

Parts are available direct from Mirage, either by calling 662-323-8287; faxing 662-323-6551 or

writing to Mirage, 300 Industrial Park Road, Starkville, MS 39759. When faxing or writing, be

sure to include a phone number you can be reach at during Mirage business hours.

Please have a credit card number available over the phone (do NOT include credit card

information in the mail), or prepay the order with a check after calling for prices.

Part numbers are listed after the schematic. Be sure you have the full part description, the model

and serial number (if used on this product), and the part number.

Table of Contents

Show Quick Links

Table of Contents