DFI P5XV3 User Manual page 33

2.2.5.6 Universal Serial Bus Ports
The system board is equipped with
two USB ports. USB allows data
exchange between your computer and
a wide range of simultaneously
accessible external Plug and Play
peripherals.
You must have the proper drivers
installed in your operating system to
use these ports. Refer to your
operating system's
documentation.
2.2.5.7 IrDA Connector
The system board is equipped with an IrDA connector for wire-
less connectivity between your computer and peripheral devices.
Connect your IrDA cable to connector J2 on the system board.
Make sure "Onboard UART 2 Mode" in the Integrated Peripherals
setup of the Award BIOS (Chapter 3) is set to the type of IrDA
standard supported by your IrDA peripheral/device.
You must have the proper drivers installed in your operating
system to use this connector. Refer to your operating system's
manual or documentation.
Pin Function
1
2
3
4
5
Hardware Installation
manual or
IRTX
GND
IRRX
IRR3
VCC
2
33