DFI P5XV3 User Manual page 17

Installing the DIM Module
A DIM module simply snaps into a socket on the system board.
Pin 1 of the DIM module must correspond with Pin 1 of the
socket.
Tab
Pin 1
1. Pull the "tabs" which are at the ends of the socket to the side.
2. Position the DIMM above the socket with the "notches" in the
module aligned with the "keys" on the socket.
3. Seat the module vertically into the socket. Make sure it is
completely seated. The tabs will hold the DIMM in place.
2.2.1.2 SIMM
The two 72-pin SIMM (Single
In-line Memory Module) sockets
use EDO or FPM x32 DRAM.
Refer to the table on the next
page for the bank locations and
modules needed
corresponding memory sizes.
Hardware Installation
Notch
Key
for the
2
Tab
17