Setting Mode - AOR AR-STV Instruction Manual

5-2-2-3 Change memory contents
To change the recorded frequency of the memory channel, perform the following steps:
1. Press and hold the MODE switch for 3 seconds.
2. The frequency on the top right of the LCD will display in reverse color.
3. Press the FREQ. switch upward or downward to change the frequency.
3. To confirm entry, press and hold the FREQ. switch again for 3 seconds.
5-2-2-4 Recording image
Press and hold the REC switch for 3 seconds.
To return to the search mode, press the MODE switch and REC switch simultaneously three times.
(The operation mode will toggle between the Search mode, Memory mode, SD card mode, and setting
mode.)

5-2-3 Setting mode

There are two (2) separate setting modes; Setting 1 mode and Setting 2 mode.
To go into the Setting mode, press the MODE switch and REC switch simultaneously several times
(depending on the current operation mode) to display Setting 1 on the LCD screen.
5-2-3-1 Setting 1 screen
Date and Time: Set current date and time for time stamp.
View Time:
Video Polar(ity): Reverse video polarity (ON/OFF)
Duration of pause time. (Parameter: 1 ~ 50 (second), STOP)
Set the view time before resuming search after detecting video signal.
If set to STOP, the AR-STV stops searching once video signal is detected.
11