Lenovo thinkcentre m83 User Manual page 70

Your computer has a special type of memory that maintains the date, time, and settings for built-in features,
such as parallel-port assignments (configuration). A battery keeps this information active when you turn
off the computer.
The battery normally requires no charging or maintenance throughout its life; however, no battery lasts
forever. If the battery fails, the date, time, and configuration information (including passwords) are lost. An
error message is displayed when you turn on the computer.
Refer to the "Lithium coin cell battery notice" in the Safety, Warranty, and Setup Guide for information about
replacing and disposing of the battery.
To replace the battery, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 40.
3. Locate the battery. See "Locating parts on the system board" on page 13.
4. Remove the old battery.
Figure 38. Removing the old battery
5. Install a new battery.
Figure 39. Installing a new battery
6. Reinstall the computer cover and connect the cables. See "Completing the parts replacement" on
page 99.
Note: When the computer is turned on for the first time after replacing the battery, an error message
might be displayed. This is normal after replacing the battery.
7. Turn on the computer and all attached devices.
8. Use the Setup Utility program to set the date, time, and any passwords. See Chapter 7 "Using the
Setup Utility program" on page 111.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 99.
58
ThinkCentre M83, M93/p User Guide