Replacing The Cover Presence Switch - Lenovo thinkcentre m83 User Manual

Hide thumbs Also See for thinkcentre m83:
Table of Contents

Advertisement

8. Insert the connector and cable of the new thermal sensor into the lower hole
align the two tabs on the plastic holder holding the thermal sensor with the two holes
chassis, and push the plastic holder until it snaps into position.
Figure 72. Installing the new thermal sensor
9. Reconnect the thermal sensor cable to the system board. See "Locating parts on the system board"
on page 13.
10. Reinstall the front bezel. See "Removing and reinstalling the front bezel" on page 41.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 99.

Replacing the cover presence switch

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
This section provides instructions on how to replace the cover presence switch (intrusion switch).
To replace the cover presence switch, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 40.
3. Locate the cover presence switch. See "Locating components" on page 12.
4. Disconnect the cover presence switch cable from the cover presence switch connector on the system
board. See "Locating parts on the system board" on page 13.
86
ThinkCentre M83, M93/p User Guide
1
in the chassis. Then
1
and
2
in the

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thinkcentre m93/p10a010a110a610a710ag ... Show all

Table of Contents