7. Slide the new front USB assembly with retainer into the card reader drive bay until it snaps into position.
Figure 33. Installing the front USB assembly
8. Connect the front USB assembly cable to the front USB connector 2 on the system board. See
"Locating parts on the system board" on page 13.
9. Locate the protective cover for the card reader drive bay on the front bezel. Remove the protective
cover by pressing the small tabs
the cover from the front bezel.
Figure 34. Removing the card reader cover
10. Reinstall the front bezel. See "Removing and reinstalling the front bezel" on page 41.
1
to the left, and then pulling the tabs to completely disengage
.
Chapter 5
Installing or replacing hardware
55