Table of Contents
Advertisement
AC1400 SLIDING GATE OPERATOR
Remote control mode
Environmental temperature
Main unit dimension
MCU logic voltage
Net weight
Emergency release key in case of power failure
4. Necessary Tools
The following tools may be necessary to install the AC1400 Gate operator. You will need
screwdrivers, an electric drill, wire cutters and a wire stripper, a socket set, and possibly
access to a welder.
5. Site Preparation
Before you begin the operator installation, the gate should be mounted and moving freely,
there should be little resistance in the movement of the gate. The gate and post must be
suitable for being automated. Check that the structure is sufficiently strong and rigid, and that
its dimensions and weights conform to those listed in the specifications table of this document.
Make sure that the gate is plumb and level. The fence posts must be mounted in concrete.
The AC1400 is powered by 110V/60Hz AC power, therefore if you have not already done so;
wire a waterproof outlet near the gate following proper safety standards for your area. If you
are not experienced with this type of wiring or if your area requires it, hire a professional
electrician to perform this as well as wire in the AC1400 in the electrical section. The AC1400
requires at least a 10A service. Make sure your electrician takes into account the voltage drop
involved in running many feet of wire to your installation location. If an insufficient gauge of
wire is used, there will be insufficient power at the site to operate the operator.
Sliding gate operator
Operator Base
Remote control
Master Links
Chain
Chain Bolts
Chain Brackets
"U" Bolts for square & round gate frame
2 ¾_ (M8x 70mm) Bolts for mounting operator to the base and washers
2 ½_ (M8x65mm) Bolts for mounting Magnet brackets and washers
3 ¾_Anchor bolts, Anchors, Washers and Nuts (In the same bag with manual
release key)
5/8_ (M8x15mm) Socket Head Cap screws for mounting chain box
Manual release key
Magnet brackets
Magnets
2
1m BVR 0.7mm
antenna
User's manual
6. Mechanical Installation
Single Button
-20°C~+50°C
263×240×153mm
DC5V
21 Kg
Table 2 Parts List
Item
3
Quantity
1
1
2
2
1
2
2
4
4
4
4
4
2
2
2
1
1
Hide quick links:
Advertisement
Table of Contents
