Siemens Simatic S7-1500 Manual page 13

Properties
● Technical properties
– Fail-safe digital module for use in the S7-1500 automation system and in the
– PROFIsafe
– PROFIsafe address type 2
– Supports the RIOforFA-Safety profile (on S7-1500 F-CPUs)
– 16 inputs (SIL3/Category 3/PLd) or 8 inputs (SIL3/Category 4/PLe)
– 4 outputs for sensor supply
– Use of various interconnection types are possible (1oo1 & 1oo2)
– Supply voltage L+
– Sink input (P-reading)
– Suitable for connection of 3/4-wire sensors according to IEC 61131:2007, type 1
– Channel-specific assignable input delay 0.4 ms to 20 ms
– Internal short-circuit-proof sensor supplies for each channel group
– External sensor supply possible
– Status display RUN (green LED)
– Status display module diagnostics (red LED)
– Status display channel status/channel diagnostics per input (green/red LED)
– Status display supply voltage (green LED)
– Diagnostics, e.g., short-circuit, channel-specific
– Diagnostics, e.g., load voltage missing, module-specific
– Channel-specific or module-wide passivation
● Supported functions
– Firmware update
– I&M identification data
The fail-safe performance characteristics in the technical specifications apply for a mission
time of 20 years and a repair time of 100 hours. If a repair within 100 hours is not possible,
switch off the supply voltage of the affected module before 100 hours expires.
Follow the repair procedure described in section Diagnostic alarms (Page 51).
Digital input module F-DI 16x24VDC (6ES7526-1BH00-0AB0)
Manual, 01/2016, A5E03858068-AA
ET 200MP distributed I/O system.
WARNING
Product overview
2.1 Properties
13