Table of Contents
Advertisement
Getting started
Pairing the headset with a Bluetooth device using NFC
The following sections describe, using a smartphone as an example, how to
pair your MB 660 Wireless headset with a Bluetooth device using NFC. If the
instructions provided do not work on your device, proceed as described in the
instruction manual of the device.
Switch the headset on and ensure that Bluetooth is activated on the headset
X
when performing this procedure.
1.
Activate NFC on your smartphone.
2.
Scan the smartphone to the NFC panel on the left ear cup of the headset.
The LEDs flash white in sequence and you hear the voice prompt "pairing".
The headset is in pairing mode.
At this point, if you decide to cancel pairing, press the Sound Effect Mode
button once. You hear the voice prompt "pairing cancelled" after a few
seconds.
3.
Choose "Yes" in the pairing confirmation dialog of your smartphone (this
step may vary depending on your smartphone).
If pairing was successful, you hear the voice prompt "connected". The LED
flashes white 3 times.
Menu
Menu
NFC on
NFC o
NFC o
› power on ‹
› pairing ‹
If no connection could be established within 5 minutes, pairing mode is
terminated and you hear the voice prompt "no device found". Restart the
headset by switching it off and on again, and repeat the pairing procedure.
L
Left
Connect to Bluetooth device?
Yes
No
› connected ‹
3X
MB 660
| 15
Hide quick links:
Advertisement
Table of Contents
