Advertisement
Using your machine
CAUTION: Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
IMPORTANT: Your dirty water tank is fitted with a float. When the dirty water tank is full, or the floor head is not in contact
with the carpet the float will shut off the suction on the carpet washer. You will be able to hear if this has happened as the
motor noise on the machine will increase. Once the float is activated, empty the dirty water tank if full. If the dirty water tank
is not full then turn off your machine at the power switch and wait for the float to settle.
Filling the water/solution tank
Press clean water/
Twist solution tank
solution tank release
cap anti-clockwise
button, pull and lift to
and remove.
remove tank.
Press clean water/
solution tank release
button, pull and lift to
remove tank.
Pour required amount of
Fill the clean water tank
carpet cleaning solution
with warm water
into tank. Tighten cap
(max 40'C).
before returning tank
to unit.
TIP
NOTE: Carpets should be dry vacuumed thoroughly before washing. For heavily soiled areas, it may be necessary
to repeat the cleaning process. Make crisscrossing strokes to the original pattern and overlap each pass.
Washing carpets
Pour required amount of
Fill the clean water/
carpet cleaning solution
solution tank with warm
into the clean water/
water (max 40'C).
solution tank.
Press the recline
Squeeze the trigger to
pedal and pull
release solution and
handle backwards.
water mix.
For best results apply
Turn wash/rinse dial
water/solution on the
to 'rinse'. Only water
forward stroke and
is released to remove
release the trigger to pick
solution residue.
up water/solution on the
backward stroke.
Using your machine
Turn wash/rinse dial to
Plug into mains,
'wash'. The SpinScrub
press the On/Off button
brushes and brushbar
to switch on.
deep clean your carpets
with water and solution
removing dirt and stains.
TIP
Advertisement
