Assembly And Use For The Cutting Discs - Ninja BL773CO Owner's Manual

Assembly and Use of the Cutting Discs
WARNING: The Cutting Discs are sharp. Always use the finger holes when placing or removing the cutting
discs. Failure to do so will result in a risk of laceration.
WARNING: Remove utensils prior to processing. Failure to remove may cause the bowl to be damaged or to
shatter, which may cause personal injury.
WARNING: Never leave the appliance unattended while in use.
IMPORTANT: Make sure that the motor base is plugged in for use.
Fig. 6
NOTE: The feed chute lid features a two part pusher to guide food
through the chute. Use the full pusher for larger items such as
cucumbers. Twist and pull to remove the smaller pusher and use the
narrow chute for smaller items such as carrots.
IMPORTANT: Only use Speed 1 DOUGH/DISC when using either
cutting disc attachment.
NOTE: The Slicing/Shredding Disc is reversible. Use the side labeled
"Slicer" for Slicing. Carefully flip the disc over to the side labeled
"Shredder" for shredding.
1 Review warning statements at the top before proceeding to number 2.
2 Place the motor base on a clean, dry, level surface such as a counter
or table top. (Fig. 6)
3
Secure the bowl onto the motor base.
4
Place the spindle inside the bowl.
5
Use the finger holes to grasp the selected disc and place it over the
spindle.
6
Place the feed chute lid on the bowl and turn clockwise until you here a click
indicating the lid is locked in place. (Fig. 6)
7 Plug the power cord into the electrical outlet and press the power
button ( ) to turn the unit "On".
8 Select Speed 1 DOUGH/DISC on the control panel. The disc will
begin spinning.
9
Add the food that you want to slice, shred or grate through the feed
chute on the lid. (Fig. 6) Use the two-part food pusher to help guide
the food through the feed chute. The middle piece of the food pusher
is removable to use for smaller ingredients.
10 When finished, stop the appliance by pressing the power button ( )
and wait for the disc to stop turning. Press the button on the feed chute
lid located near the handle to unlock and turn the lid counter-clockwise.
Lift to remove from the processor bowl. Using the finger holes, carefully
lift the cutting disc out of the bowl and remove the spindle.
11 To release the motor base from the counter or
table top, lift the base up from underneath the
sides of the unit. Release paddles on both sides
will help to disengage the suction feet from the
surface.
www.ninjakitchen.com 10