Battery Installation - Invacare trackease smart system User Manual

Battery Installation

Replace Battery when Low or Dead
Battery Symbols appear in Display
or Meter does not turn on.
1. Lift tab on Battery Cover.
2. Turn Meter over, tap gently
to loosen and remove Battery.
3. Insert new Battery, positive
("+") side up. Close cover.
Note: Use non-rechargeable
3V
(#CR2032).
4. Discard old battery in appropriate container.
5. Turn Meter on. If Meter will not turn on, check
that Battery was installed properly. If not,
reinsert Battery and try again. Call for
assistance if problem persists.
Caution!
Note: Replacing battery may affect date and time
settings. Check date and time by pressing
Lithium Battery
Batteries might explode if mishandled or
incorrectly replaced. Do not dispose of battery
in fire. Do not disassemble or attempt to
recharge Battery. Dispose according to
local/country specific regulations.
and releasing. To reset, see Set Up.
24
Low Dead