Starting Up The Device - iBall Slide nimble 4GF User Manual

The battery can be charged and discharged many times, but it will eventually wear out. When the
talk and standby times are noticeably shorter than normal, get the battery replaced. Use only iBall
approved batteries, and recharge your battery only with iBall approved chargers designated for
this device. If a battery is being used for the first time or if the battery has not been used for a
prolonged period, it may be necessary to connect the charger, then disconnect and reconnect it
to begin charging the battery. If the battery is completely discharged, it may take several minutes
before the charging indicator appears on the display or before any calls can be made.
Note: Only the AC adapter provided with your device must be used to charge the device.
Connect the USB connector of the AC adapter to the sync connector on your device, and then
plug in the AC adapter to an electrical outlet to start charging the battery.
As the battery is being charged while the device is ON, a charging icon appears in the title bar of
the Home screen. After the battery has been fully charged, a full battery icon appears on the title
bar of the Home screen.
Warning!
• As a safety precaution, the battery stops charging before it overheats.

3. Starting up the Device

Power ON / OFF
To power OFF your Slide, press & hold the POWER key. On release, the options menu opens.
Select ‗Power OFF' from the given options and confirm. This will turn OFF the device.
To power ON again, press & hold the POWER key. The iBall power start up animation will appear
on the screen indicating that the device is starting.
Silent mode
To put your device on silent mode quickly, press & hold the – volume down button to zero
volume. The volume level 0 is the vibration mode. Long Press on Home screen and select
SettingsAudio Profile, select ‗Silent' radio button. You can only activate silent profile but cannot
customize it. You can also long press the power key and you will get the option to change user
profile.
Screen time out
After a period of inactivity, your screen will go to sleep (display will turn black). In sleep, your
Slide uses less battery power. You can control this behavior by following the below mentioned
steps:
Set screen timeout period
1. Long Press on Home screen and select Settings.
2. Select Display option.
3. Select ―Screen Time out‖, to set the time period of sleep mode.
Press POWER key once to OFF display immediately. While on a call, to lock your control buttons
and screen from accidental touch activation, press POWER key.
You can increase the security of your Slide by setting Screen Lock pattern. Once set, in order to
unlock your screen, you'll have to draw the correct unlock pattern. You can set your screen lock
pattern as follows:
11