HP 780019-S01 Maintenance And Service Manual page 63

Remove the clear processor socket cover. Retain the processor socket cover for future use.
3.
Install the processor. Verify that the processor is fully seated in the processor retaining bracket by
4.
visually inspecting the processor installation guides on either side of the processor. THE PINS ON
THE SYSTEM BOARD ARE VERY FRAGILE AND EASILY DAMAGED.
CAUTION: Do not press down on the processor. Pressing down on the processor may cause
damage to the processor socket and the system board. Press only in the area indicated on the
processor retaining bracket.
CAUTION: Close and hold down the processor cover socket while closing the processor
locking levers. The levers should close without resistance. Forcing the levers closed can
damage the processor and socket, requiring system board replacement.
Close the processor retaining bracket. When the processor is installed properly inside the processor
5.
retaining bracket, the processor retaining bracket clears the flange on the front of the socket.
Removal and replacement procedures 63