XP Metal Detectors Deus V4 User Manual page 9

Switch on
the remote control
(after extending stems and holding the coil
away from the ground and any metal)
By default you begin by using the 1 - BASIC factory program which is suitable for general use.
If you wish to test one of the 10 other factory programs,
simply scroll through them with
To switch off the Dēus
Hold down Power for two seconds
Press left- and right-hand buttons simultaneously
Do not switch the Dēus on when the coil is near metal, inside a car, or when the stem is collapsed,
as this may interfere with calibration and lead to abnormal performance. If this should occur, switch
off and move away from any metal masses before switching it on again. Nevertheless, this does not
represent any risk to the equipment or its electronics. But may give abnormal results !
STARTING UP
After charging your device. (pg 29)
- - - -
Validate or not the use
of the loudspeaker
The LED on the coil gives 20 long, successive flashes to indicate that it is waking
up and recalibrating.
Once recalibration is complete, the coil becomes operational and its LED flashes
every second.
- - - -
NO YES
on the remote control.
DISC
SENS
TONE
GND
VOL
FREQ
COIL
Switch on
the headphones
on the headphones.
07