Appendix-Rs232 Control Commands - Eiki EK-100W Service Manual

Appendix
Serial Control
2.Basic commands
Distinguish the letter case, and enter Each command ends with [CR] (enter) .
Command Option
C00 POWER ON
POWER OFF(Shut down Immediately ) C33
C01
C02 POWER OFF
C36 HDMI1
C37 HDMI2（MHL）
C05 VGA IN 1
C06 VGA IN 2
2.1 POWER ON command
Command
"C00"[CR]
Power ON action
If the projector already in "Power ON" action, thus no need any command
Details
During Power on countdown send "C00" command can stop the countdonw action.
Receive Successfully
Return
Value
Receive unsuccessfully
2.2 POWER OFF command（Shut down Immediately ）
Command
"C01"[CR]
Power OFF action
Details
Send this command to shut down when you are in the power-on mode
Receive Successfully
Return
Value
Receive unsuccessfully
2.3 POWER OFF command
Command
"C02"[CR]
Power OFF action
Details
Send this command to pop up [POWER OFF] dialog box when you are in the
power-on mode,then send this command once again to power on.
Receive Successfully
Return
Value
Receive unsuccessfully
Note: [ACK] "CR" is the return value for receiving valid commands.
Command
C07
C34
C15
C16
C17
[ACK]［CR］
"？" [CR]
[ACK]［CR］
"？" [CR]
[ACK]［CR］
"？" [CR]
Option
Video
Component
S-Video
NETWORK
MEMORY VIEWER
USB DISPLAY
38