Replace The Lamp - Eiki EK-100W Service Manual

Maintenance and cleaning

Replace the lamp

When the projection lamp of the projector
reaches its end of life, the Lamp replacement
icon appears on the screen. Replace the lamp
with a new one of the same type promptly.
The timing when the lamp replacement icon
appears is depending on the lamp mode.
CAUTION
As temperature inside the projector is high,
you should cool the projector for at least 45
minutes before you open the lamp cover.
CAUTION
When the lamp isn't illuminated, it may indicate that the lamp has been damaged.
When you replace the lamp in a projector installed on the ceiling, you should stand beside
the lamp cover other than under it; for the broken glass may fall down to hurt you. To do that,
remove the lamp cover gently to avoid being hurt by falling debris. If debris drops into your
eyes or mouth, you should see the doctor immediately.
To replace the lamp, follow the steps below:
1. Power off the projector and unplug the power
cord. Then let the projector cool for at least
45 minutes.
2. Loosen the screw on the lamp cover to
remove the cover.
3. Make sure the lamp is well protected and
loosen four screws. Hold the handle to
take out the lamp.
4. Install a new lamp with the same model and
tighten the four screws. Make sure the
installation is correct. Put lamp cover in place
and then tighten the screw.
5. Plug the AC power cord and power on the
projector.
Lamp replacement icon
Lamp replacement
CAUTION
For the sake of safety, only use the lamp of
the same model. Never drop the lamp onto the
ground nor touch the glass bulb! The glass can
shatter and hurt.
Handle
Screw
Screw
Lamp cover
11