Engine - Pogo 30 Owner's Manual

4. Engine

Engine Type:
Standard Engine for Pogo 30 is the D1-13 from Volvo Penta Sail-drive. Optionally, it can be fitted with
D1-20 or D1-30. The propeller is a folding two blades from Volvo Penta as well.
Use and maintenance of the engine :
Please refer to the Volvo Penta manual called "instruction book". A complete reading of the manual
before service is recommended to prevent damage and know the wear parts of the engine.
Engine cooling inlet seacock:
It is very important to check the cooling seacock is open before starting the engine. It is located on
the sail-drive base, on portside. You can access it by the port cabin hatch.
When the engine is on, check the water circulation of the cooling system. Some water should come
out of the exhaust.
At the engine start, it is recommended to put some power for a few seconds in order to properly
initiate the cooling system.
Check lists
It is very important to correctly take care of your engine. Follow the maintenance schedule and check
the engine oil and coolant level.
Check the sacrificial anode carefully. The first one's erosion will happen quickly. Check them
regularly.
Stay up to the property of the service module and check regularly that there are no outflows (fuel,
water).
Information
If you need more information about your engine and its maintenance, please contact your Volvo
Penta dealer for assistance.
Gasoil tank:
The installed diesel tank has a capacity of 60L. It is equipped with a fuel supply cut down valve. This
valve must always be accessible
5