Stainless Steel - Pogo 30 Owner's Manual

Inspection of self-aligning ball from the connecting axis between the
rudders:
Joint-balls checkout at the end of the rudders push-rod (in the rear chest)
It is advisable t check regularly the good blockade of these ball-joints (lock nut + thread brake).
Inspection of the pilot electric ram:
It is advised to regularly verify the correct blocking of the connection between the ram axis and her
bracket (washers + nut + locknut + light sealant);
Also check the cylinder rod of the ram.

Stainless Steel

All stainless steel are 316L quality and all the screws are A4 quality. But the stainless steel becomes
tarnished and gets rusty if it was in contact with Ferro-metals (drills, keys or non-chromed
screwdrivers). You can clean this surface pollution with a remover such as Wichinox by WICHARD.
Windlass:
Preserving the proper functioning of the remote control of the windlass, it should not be stored in
the anchorage locker.
Fresh water:
During winter (in water or in winterpark), be sure to serve the whole of the circuit of water to
preserve the gel valves, pipes and fittings as well as the Group of water (if applicable). (See also
chapter on water).
17