Pogo 30 Owner's Manual page 45

Axxon Composites
Steping
a. Place the lifting strop 2 meter above center of gravity and secure it on gooseneck to
avoid sliding up.
b. In case of a mast step on the keel, put the tie rod in place and tighten them.
c. Carefully lift the mast with the crane.
d. Put the mast on mast base.
e. Secure the V1, D1 and headstay on the chainplates and tension the turnbuckles by hand.
f. Secure backstay, runner, checkstay...
g. Release tension from the crane.
III. Rigging adjustment
A. WITHOUT MAST JACK
Tools list:
- Full set of hex keys
- Full set of keys
- 30cm long adjustable wrench
- Electronic level
- Plier
Preparation
a. Be sure that running backstay, vang, halyards and mainsheet are completely loose at all
stages until final tune is complete.
Rake adjustment
a. Check the waterline to be sure the boat is floating correctly.
b. You must have a minimal tension on the verticals.
c. Adjust the forestay's length in order to have the rake required by the architect. Use
electronic level.
V1 adjustment
a. Adjust the V1's turnbuckles to create pre-bend to about 15 cm.*
b. Verify that all diagonals are loose. Otherwise loosen them.
c. Check the mast is straight laterally.
D1 adjustment
a. Tighten the D1's turnbuckles to reduce pre-bend to about 10cm.*
b. Check the mast is straight laterally.
D2 adjustment
a. Tighten the D2's turnbuckles to reduce pre-bend to about 7cm.*
b. Check the mast is straight laterally.
Page 7 of 15