Siemens 3UG4 User Manual page 42

System overview
3.6 Menu-based operation
Navigation in the menu
There are basically two ways of navigating on both menu levels:
● Brief pressing the SET key
You can jump from one parameter to the next within one menu level by briefly pressing
the SET key
Note
The setting options a device actually offers depends on the type and can be looked up in
the relevant chapters on operation in this manual.
You can find full details of menu-based operation for the individual devices in Appendix D
"Menu-based operation" (Page 389).
● Pressing and holding the SET key
By pressing and holding the SET key
versa.
– RUN → SET
– SET → RUN
42
. The order is not variable.
Entry Display at the RUN menu level
1. Current measuring value (MeasValue1 /
MeasValue2 / ...) or error symbol (Error1 / Error2 /
Error3 / ...), switching contact symbols and
monitoring methods for diagnostics
2. Threshold1
3. Threshold2
4. Threshold3
5. ...
Menu level change can be started from any display. While the SET key is pressed,
appears on the display.
After a successful change, you always arrive at the first menu item (parameter1) of the
"SET" menu level.
In the event of an error, changing to the "SET" menu level is only possible from "RUN-
②
VALUE" . If an error is indicated, the SET key must be pressed first briefly (< 0.5 s).
You can switch menus from any of the menu commands. While the SET key
pressed, appears on the display.
After a successful change, you arrive at current measuring value (measuringvalue1) or
the current error of the RUN menu level.
(≤ 0.5 s)
(> 2.5 s)
, the menu changes from RUN to SET and vice
Manual, 05/2016, NEB927043002000/RS-AC/004
Display at the SET menu level
Parameter1
Parameter2
Parameter3
...
3UG4 / 3RR2 monitoring relays
is