Fitting Thermometer With Thermometer Sensor And Cover Strips - Viessmann VITOCELL 300-B Installation Instructions Manual

DHW cylinder 500 l

Fitting thermometer with thermometer sensor and cover strips

5.
4.
2.
3.
Fig. 7
Cylinder type plate
A
1. Fit the thermal insulation jacket evenly by patting it
against the cylinder body.
2. Route the sensor lead of the upper thermometer
(shorter lead) and the lower thermometer (longer
lead) through the cover strip and push in the ther-
mometers.
3. Fit the front cover strip.
4. Insert the upper thermometer sensor as far as it will
go into the hole in the cylinder locking cap.
5. Secure the sensor with clips to prevent it being
pulled out.
6. Guide the sensor lead of the lower thermometer at
the back through the thermal insulation jacket to the
outside.
(cont.)
A
8.
6.
1.
7.
7. Fit the back cover strip.
8. Affix the type plates.
9.
Fig. 8
Seal the hole next to the cover strip below the ther-
mometer with a cover (pipe collar).
11