DHW cylinder 500 l
Fitting the cover
A
2.
Fig. 9
Cap with logo
A
Installing the thermometer and the cylinder temperature sensor
The cylinder temperature sensor for the heating side
■
is supplied in the control unit pack. The cylinder tem-
perature sensor for the solar side is supplied in the
solar control unit pack.
Reducers and sensor wells with sensor retainers are
■
supplied in the separate cylinder pack.
Secure the sensor and the thermometer sensor to
■
the outside of the sensor retainer contact spring (not
in the groove) so that it is flush with the front of the
spring.
12
(cont.)
1.
Never wrap insulating tape around the sensors.
■
Seal in the reducers and sensor wells.
■
Insert the sensor retainers and sensors into the sen-
■
sor wells as far as they will go.