Card Reader - Lenovo ThinkStation P710 User Manual

7. Position the flex module cover on the flex module. Ensure that the rail guides on the bottom of the flex
module cover engage the rails on the flex module. Then, push the cover to the front of the flex module
until it snaps into position.
Figure 32. Reinstalling the flex module cover
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 133.

Card reader

To install or replace a card reader in the flex module, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 61.
2. Remove the flex module from the front of the computer. See "Device in the optical-drive bay" on page 64.
3. Lift the clip on the rear of the flex module. Then, slide the flex module cover to the rear of the flex
module to remove the cover.
Figure 33. Removing the flex module cover
4. If you are replacing a card reader, do the following:
a. Disconnect the card reader cable from the system board. See "Parts on the system board" on page 7.
.
Chapter 7 Installing or replacing hardware
75