Lenovo ThinkStation P710 User Manual page 103

4. Flex the sides of the bracket and align pins
new storage drive.
Note: If you are installing a 2.5-inch hard disk drive, ensure that the circuit board faces downward and
the connectors 2 face toward the front of the bracket.
Figure 62. Installing the storage drive into the type
5. Slide the bracket with the new storage drive into the storage drive bay.
Note: Ensure that the storage drive is on the upper side. You might need to flip over the storage
drive bracket.
Figure 63. Installing the type
6. Connect the signal cable and the power cable to the new storage drive, and then close the handles
on both sides of the bracket.
1 on the bracket with the corresponding holes in the
1
bracket
1
storage drive bracket
.
Chapter 7 Installing or replacing hardware
91