Connections - Pioneer DDJ-WEGO4 Operating Instructions Manual

0 Launching the settings utility software
For Windows 10/8.1
Click [Pioneer]>[DDJ_WeGO4 ASIO Settings Utility] from [Apps
view].
For Windows 7
Click [All Programs] > [Pioneer] > [DDJ_WeGO4] > [DDJ_WeGO4
ASIO Settings Utility] from the [Start] menu of Windows.
0 Adjusting the buffer size
In the same way as the buffer size setting in VirtualDJ LE 8, decreas-
ing the value of the [Kernel Buffers] setting lowers the transfer delay
(latency) of the audio data, while increasing the value reduces the ten-
dency for dropouts in the audio data (breaks in the sound).
! If the [Buffer Size] or [Kernel Buffers] number is made large, drops
in the data (breaks in the sound), etc., occur less easily, but the time
lag due to transmission delays in the audio data (latency) increases.
0 If breaks in the sound occur with the default
setting
Launch [DDJ_WeGO4 ASIO Settings Utility] and change
[Kernel Buffers] to [4].
0 If no breaks in the sound occur with the default
setting
Launch [DDJ_WeGO4 ASIO Settings Utility], change
[Kernel Buffers] to [2], and check that no breaks in the
sound occur.
! If breaks in sound occur, change [Kernel Buffers] of [DDJ_WeGO4
ASIO Settings Utility] to [3].
Checking the version of the driver
software
For Windows 10/8.1
From [Apps view], click [Pioneer] > [DDJ_WeGO4 Version Display
Utility].
For Windows 7
Click [All Programs] > [Pioneer] > [DDJ_WeGO4] > [DDJ_WeGO4
Version Display Utility] from the Windows [Start] menu.
! You can check the firmware version of this unit on the screen.
! The firmware version is not displayed when this unit is not connected
to the computer or when this unit and computer are not properly
communicating.

Connections

1 Connect speakers with a built-in amplifier, a power
amplifier, etc. to the [MASTER] output terminals of this
unit.
! An audio cable (RCA) is not included with this product. Please pro-
vide it yourself separately.
R L
Speakers with built-in amplifier,
power amplifier, etc.
! For details on connecting the input/output terminals, see page 7 .
! Set the volume of the device connected to the [MASTER] terminals
(speakers with built-in amplifier, power amplifier, etc.) to an appropri-
ate level. Note that the output sound may be loud if the volume is set
too high.
2 Connect headphones to an [PHONES] output terminal
of this unit.
! Connect stereo headphones with an impedance of 32 W or higher.
Headphones with an impedance less than 32 W and mono head-
phones are not supported.
! Do not connect headphones simultaneously to the stereo phone jack
and the stereo mini-phone jack.
Headphones cord
To headphones
For checking
the output sound
Headphones
3 Connect this unit to your computer via a USB cable.
! Be sure to connect directly using the USB cable included with this
product. A USB hub cannot be used.
USB cable
(included)
USB
Computer
31
En