Bottom Timer Mode - Preparing To Dive; Bottom Timer Mode - During A Dive; Bottom Timer Mode - After Diving - DEEPBLU cosmiq+ Product Manual

SECTION 5 – INSTRUCTIONS FOR USE
Mode once you descend past 2 meters/6.5 feet.
Manual activation: If Bottom Timer Mode is not your default underwater mode, you must activate
it manually before commencing your dive. Navigate to Bottom Timer Mode using the MODE
button. Enter the water and begin descent while in Bottom Timer Mode.
When doing manual activation, remember to navigate to Bottom Timer Mode less than 3 minutes
before you begin your descent. If you set COSMIQ
before you descend, COSMIQ
switch to the default underwater mode upon detection of pressure.
NOTE: On the surface, COSMIQ
Therefore, there may be a slight delay between descending below 2 meters/6.5 feet and Bottom
Timer Mode activating. During a dive, the sampling rate in Bottom Timer Mode is 1 second.
5.3.2 Bottom Timer Mode – During a Dive
Once you descend past 2 meters/6.5 feet, COSMIQ
button will be disabled for the duration of the dive. No other modes can be accessed during the
dive. When you commence a new stage, press ADJUST to reset the average depth and secondary
dive time.
During a dive using Bottom Timer Mode, the following information will be displayed:
- Current depth (Depth in meters/feet)
- Average depth (Depth in meters/feet; replaces the letters 'BOT'; resettable)
- Deepest depth (Max in meters/feet)
- Dive time (Dive Time in minutes)
- Secondary dive time (Time in minutes:seconds; resettable)
- Water temperature (Temp in °C/°F)
- Current time (Time in hours:minutes)
- Ascent rate bar
Note that on the original COSMIQ model, average depth and stage time are not available in
its Gauge Mode.
5.3.3 Bottom Timer Mode – After Diving
Upon surfacing from a dive, COSMIQ
surface for less than 2 minutes and then descend again, COSMIQ
of the previous dive and the calculations and measurements will continue from where they left off.
After a dive in Bottom Timer Mode, COSMIQ
be displayed on the screen when COSMIQ
Dive data recorded during the dive will be saved in Log Mode.
When no pressure is detected by COSMIQ
automatically to Watch Mode.
BACK TO INDEX
+
will revert back to Watch Mode, and will therefore automatically
+
refreshes its sensors and captures data in 15-second intervals.
+
+
will remain in Bottom Timer Mode for 2 minutes. If you
+
will begin to count the Surface Interval Time. It will
+
is in Watch Mode.
+
for 3 minutes upon surfacing from a dive, it will switch
+
26
to Bottom Timer Mode more than 3 minutes
will lock into Bottom Timer Mode. The MODE
will consider this a continuation
+