LeapFrog BOLT User Manual page 25

Hide thumbs Also See for BOLT:
Table of Contents

Advertisement

STEP 1
Locate the orange push-in coupling on the right print
head, connecting the print head to the filament guide
tube. Remove the tube from the print head by pushing
the orange coupling down and pulling tube upwards
in the opposite direction. Let the tube disconnected
until the filament is loaded correctly.
Loading filament can also be done without
NOTE
disconnecting the push-in coupling, but it is strongly
advised to use this method in order to ensure success
loading filament and know what is happening.
STEP 2
On the Bolt Software, select the
Print tab and choose the Swap Right
option for the right extruder.
It will ask you to confirm the unload
process; please do so.
The printer will first pre-heat the selected nozzle to help load and unload
NOTE
filament. This is will extend the life of your nozzle blocks and will help prevent clogs.
STEP 3
You'll then be prompted to physically unload and roll of the filament spool that was
previously loaded in the printer, if applicable. To do this, open de filament
compartment on the right side of the Bolt and remove the filament spool from the
filament compartment. The right extruder will then be empty and available to load the
replacement roll of filament.
25

Advertisement

Table of Contents
loading

Table of Contents