Download Print this page

LeapFrog Bolt Quick Start Manual

Hide thumbs Also See for Bolt:

QUICK START GUIDE

Table of Contents

Need help?

Do you have a question about the Bolt and is the answer not in the manual?

Page 1 QUICK START GUIDE...
Page 2: Get Started
1 GET STARTED 3 UNBOXING When the Bolt is removed from it’s shipping Thank you for purchasing the Bolt from packaging, it still has protecting packaging on Leapfrog 3D Printers. This guide will show you the out-, and inside of the Bolt.
Page 3 4 POWER 5 BOLT SOFTWARE Plug the power cord in the back of the Bolt The Bolt is fitted with our most advanced and connect the Bolt to a grounded (!) wall software. It is WiFi accessible and provides outlet.
Page 4: Load Filament
At each position, the distance between the Get the filament spool you would like to load bed and nozzle should be checked, this should into the Bolt and cut the end of the filament be roughly 0.150mm or as thick as a standard in a point.
Page 5 Press load, the nozzle will heat up and wait until the nozzle is heated. Gently push the end The Bolt is ready to print. Go to the Jobs tab of the exposed filament of the tube, directly and select the pre-installed Bolt sample print.
Page 6: General Information
2408 AW, Alphen a/d Rijn The Netherlands follow us on: You have successfully finished your first print. For more information on the Bolt, see to our full manual online: cloud.lpfrg.com/media/boltusermanual.pdf For more information on 3D printing, go to courses.lpfrg.com. Here you can find information on 3D printing and advice, in order to successfully print your own projects.