Table of Contents
Advertisement
iLuv
Stereo Audio System for Your iPod
TM
GETTING STARTED
Installing the Remote Control Battery
The remote control battery has been previously installed and ready for operation for the first time use. When the remote control
stops functioning, you must replace the battery with a new one. To do so, you must first locate the battery compartment on the
side of the remote and follow the three steps below:
1.
Squeeze the notch labeled "Tab A" while pulling the "battery door latch B" out towards you. This will allow the battery
holder to release and pop out. Please refer to the picture in the right side.
2.
Insert a "CR2025" 3V lithium battery. Make certain to follow the correct polarity, following the directions of the
corresponding symbols (+/-).
3.
Secure battery and push the battery holder back into the remote control until it is fully inserted.
Installing the AM Loop Antenna
For AM radio operation, locate the AM antenna jack on the back of the unit, and then plug the AM loop antenna into the connector. To achieve the best
reception possible, it is recommended to have a distance of 12" between the AM antenna, the unit and the iPod.
Installing the Dock Adapter
To guarantee that your iPod will fit properly into the built-in universal dock, we have included several detachable dock adapters for old iPod players with this
product. Please check the bottom of dock adapters to see the compatibility with your iPod.
1.
How to insert a dock adapter
a.
First choose the dock adapter that corresponds with the type of iPod you would like to dock. Using the correct dock adapter ensures the
proper fit for your iPod.
b.
Gently push the dock adapter down into the universal dock.
c.
Carefully place your iPod into the universal dock. Please note that iPod must not be in a case or "Skin".
2.
How to remove the dock adapter
a.
First remove your iPod, then grasp the dock adapter and lift upwards carefully.
- 7 -
V11M10_IM_EN_11012006
www.i-Luv.com
Hide quick links:
Advertisement
Table of Contents
