Troubleshooting - Bissell PET 2069 SERIES User Manual

Troubleshooting

Problem Possible causes
Solution tank empty
Reduced
spray OR
Lint screen on solution tank
no spray
cap clogged
in upright
Upper body not properly attached
mode
properly.
Solution tank empty
Spray nozzle clogged
Reduce spray
Pump needs priming
or no spray
attachment
Machine is reclined
ReadyTools dial is set to "FLOOR
CLEANING"
Collection tank not aligned/
secured
Collection tank full
Removable nozzle installed
improperly
Deep cleaner
not picking
Removable nozzle full of debris
up cleaning
solution
Red lint screen under collection
tank clogged
ReadyTools dial not set properly
Handle not reclined.
Brush not
turning
Please do
not return
this product
to the store.
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a BISSELL product.
WARNING
To reduce the risk of electric shock, push power button
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Remedies
Refill tank with water and formula
Soak solution tank cap in warm water
and then rinse under running water
Repeat steps 1-4 on page 5.
Refill tank with water and formula
Clean spray nozzle by rinsing tool
under water
Place tool on floor and press spray
trigger
Return machine to full upright
position until it locks into place
Choose "TOOLS" setting on
ReadyTools dial.
Check tank alignment and secure
with side latches
Empty tank
Unplug unit. Align four "hooks" into
bottom first, then snap into place
on top
Unplug unit. Remove nozzle and
rinse under running water
Remove debris from lint screen
Choose either "FLOOR CLEANING"
or "TOOLS" for desired cleaning
method
Push the black detent pedal on
the back of the unit to activate the
brush. Follow step 4 under "Carpet
cleaning" on page 7.
www.BISSELL.com
11