Installation Guide For Optional Plaster Ring - Tannoy CVS 4 (EN54) Operation Manual

6.3. Installation Guide for Optional Plaster Ring

An optional plaster (mud) ring bracket is available from Tannoy. This bracket is designed to be pre-installed
into newly constructed, non-suspended ceilings.
1. Nail or screw the plaster ring to the joists. (Fig.1)
2. Lay the speaker wiring to where the speaker will be fitted and
complete the plastering work on the ceiling.
3. Cut out the hole in the ceiling using a pad saw. (Fig.2)
4. Go to section 7 for instructions on wiring then return to point 5
below.
5. Slide the speaker assembly through the hole and turn the
screws to extend the mounting wings. Tighten the screws until a
firm grip is achieved. If using a power driver, Tannoy recommends
a torque setting of 1.5 Nm. (Fig.3)
DO NOT OVERTIGHTEN!
6. Connect a secondary support line to safety tab. Some
construction codes require use of this secondary support point,
which should connect to a separate secure support point using a
suitable support line. Consult construction codes in your region.
7. Insert grille by pushing it onto the speaker. (Fig.4)
6.3. Installation Guide for Optional Plaster Ring
CVS (EN54) Operation Manual rev 1.1.1
Fig.1
Fig.2
Fig.3
Fig.4
9