Remote Control Code - Panasonic SC-MAX8700 Owner's Manual

"F61"
•
Examine and correct the speaker cords connection.
•
Disconnect the USB device. Turn off the system and then
turn on again.
"F703"
•
Examine the Bluetooth ® connection.
•
Disconnect the Bluetooth
then turn on again.
"F76"
•
There is a problem with the power supply.
•
Disconnect the AC power supply cord and consult your
dealer.
"F77"
•
Disconnect the AC power supply cord and consult your
dealer.
"NO DISC"
•
You have not put in a disc.
"NO PLAY"
"UNSUPPORT"
•
Examine the content. You can only play supported format.
•
The system may have a problem. Turn off the system and
then turn on again.
"NO TRACK"
•
There is no album or track in the USB device.
"PLAYERROR"
•
An unsupported MP3 file has been played. The system will
skip that track and play the next one.
"REMOTE 1"
"REMOTE 2"
•
The remote control and the main unit are using different
codes. Change the code of the remote control.
–
When "REMOTE 1" is shown, press and hold [OK] and
[1] for a minimum of 4 seconds.
– When "REMOTE 2" is shown, press and hold [OK] and
[2] for a minimum of 4 seconds.
"TEMP NG"
• The temperature protection circuit has been activated, and
the system will turn off. Let the unit cool down before
turning it on again.
• Check that the ventilation opening of the unit is not
obstructed.
•
Ensure this unit is well ventilated.
"USB A NO DEVICE"
"USB B NO DEVICE"
•
The USB device is not connected. Examine the connection.
"USB OVER CURRENT ERROR"
•
The USB device is using too much power. Disconnect the
USB device, turn off the system and then turn on again.
"VBR"
•
The system cannot show the remaining play time for
variable bit rate (VBR) tracks.
device. Turn off the system and
®

Remote control code

When other Panasonic equipment responds to the
remote control of this system, change the remote control
code for this system.
Preparation
Press [RADIO/AUX] to select "AUX 1" or "AUX 2".
█
To set the code to "REMOTE 2"
1
Press and hold [RADIO/AUX] on the main unit and
[2] on the remote control until "REMOTE 2" is
shown.
2
Press and hold [OK] and [2] for a minimum of
4 seconds.
█
To set the code to "REMOTE 1"
1
Press and hold [RADIO/AUX] on the main unit and
[1] on the remote control until "REMOTE 1" is
shown.
2
Press and hold [OK] and [1] for a minimum of
4 seconds.
System memory reset
Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1
Disconnect the AC power supply cord.
2
While you press and hold [1] on the main unit,
connect the AC power supply cord again.
Continue to press and hold the button until
"– – – – – – – – –" is shown.
3
Release [1].
All the settings are set back to the factory preset.
It is necessary to set the memory items again.
19
19