Table of Contents
Advertisement
Steam
en
Dough proving setting
Dough will prove considerably more quickly using the
"Dough proving T" type of heating than at room
temperature and does not dry out.
Use the information in the tables to select the
appropriate setting. ~ "Tested for you in our cooking
studio" on page 42
If the water tank runs dry during the operation
Note:
with the Dough proving setting, the operation is
interrupted. Fill the water tank.
Starting
Fill the water tank.
1.
Only switch on the Dough proving setting
Note:
once the cooking compartment has completely
cooled down (to room temperature).
Touch the Menu field.
2.
Touch the "Steaming" text field.
3.
Touch the "Dough proving" text field.
4.
The temperature is in focus.
Set the temperature using the rotary selector.
5.
Touch the "Duration" text field and set the duration.
6.
A duration is always required for the steam
Note:
types of heating.
Press the l Start/Stop button to start.
7.
The appliance begins to heat up.
Once the duration has elapsed, an audible signal
sounds. The appliance stops heating. The duration 00
m 00 s is shown in the display.
When your dish is ready, switch off the appliance using
the ÿ On/Off button.
Changing
You can change the settings as usual.
To change the temperature or the duration, touch the
corresponding text field and change using the rotary
selector. The change is adopted immediately.
To change the type of heating, interrupt the operation
beforehand using the l Start/Stop button.
Filling the water tank
The water tank is located behind the control panel.
Before starting an operation with steam, open the
control panel and fill the water tank with water.
Make sure that you have set the water hardness range
correctly. ~ "Basic settings" on page 29
:
Warning – Risk of injury and risk of fire!
Only fill the water tank with water or with the descaling
solution that is recommended by us. Do not pour any
flammable liquids (e.g. alcoholic drinks) into the water
tank. Due to hot surfaces, vapours from flammable
liquids may catch fire in the cooking compartment
(explosion). The appliance door may spring open. Hot
steam and jets of flame may escape.
22
:
Warning – Risk of burns!
The water tank may heat up while the appliance is in
operation. Wait until the water tank has cooled down
after the previous appliance operation. Remove the
water tank from the water tank recess.
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Notes
If your water is very hard, we recommend that you
■
use softened water.
If you use only softened water, you can set your
■
appliance to the "softened" water hardness range.
If you use mineral water, set the water hardness
■
range to "4 very hard".
If you use mineral water, you must only use non-
■
carbonated mineral water.
Touch the v field.
1.
The control panel is automatically pushed forwards.
Pull the control panel forwards with both hands and
2.
then push it upwards until it locks into place (Fig.
Lift the water tank and remove it from the water tank
3.
recess (Fig.
).
"
Press down on the lid along the seal to prevent
4.
water from leaking out of the water tank.
Remove the cover ‚ (Fig.
5.
Fill the water tank with cold water up to the "max."
6.
mark (Fig.
).
$
).
#
).
!
Advertisement
Table of Contents
