Table of Contents
Advertisement
Installation
Calibration switch
• Place the scale on a table.
• Connect the adaptor pin in to the scale adaptor jack. Adaptor
jack is located on therear side of the scale.
and will be starting self checking.
• After self checking, display will be come to normal weighing
mode.
• Warm-up time of 15 minutes stabilizes the measured values
after switching on.
• Calibrate with exact calibration weights, minimum 1/3 of
the scale capacity needed for calibration. For calibration see
details in parameter.
Scale is now ready for operation/ use.
USB Connecter (selectable)
RS-232 Connecter (selectable)
Adaptor Jack
• Adaptor connects into your AC power
socket.
• Turn on the On/Off key. If you want to
turn off, press the key again.
• Display will be show the version number
Advertisement
Table of Contents
