Installation - WEIGHSOUTH WSI-602 Instruction Manual

Unpacking
Carefully take the Unit out of its package, make sure its not damaged and
all accessories are included.
• Remove the weighing scale from the carton.
• Remove the protective covering. Store the packaging
if you need to transport the scale later.
• Inspect the scale and terminal for damage. Make sure all com-
ponents are included.
Accessories,
1. Scale
2. Adaptor
3. Product manual
Level Adjusting
Place the scale on a firm surface.
Check the water mark. If bubble is not in cen-
ter, adjust the leveling feet until the bubble is
in the center circle. Check the level when you
change the location.
Charging Battery
• To charge the battery insert the adaptor pin into the jack, the
jack is locatedon the rear side of the scale. The adaptor simply
plugs into a standard wall outlet. The scale doesn' need to be
turned on.
• The battery should be charged for 12 hours for full capacity.
• The display has an indicator that shows the charging status of
the battery. When the scale is plugged into the main power the
internal battery will be recharged. If the indicator is off, the bat-
tery has a full charge. If it is on, the battery is nearly discharged
and if blue, the battery is being charged.
• Do not use any other type of power adaptor than the one sup-
plied with the scale.
• Verify that the AC power socket outlet is properly protected.
Note: Please charge the battery before using the scale for the first time

4. INSTALLATION