Before Washing For The First Time; Transportation - Bosch WAT28660GB Instruction Manual And Installation Instructions

The mains cable is only replaced by
■
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
No multiple plugs/couplings or
■
extension cables are used.
If an earth-leakage circuit breaker is
■
used, only a type which displays this
symbol is used: z.
Only this symbol guarantees
compliance with the currently
applicable regulations.
The mains plug can be accessed at
■
all times.
The mains cable is not bent,
■
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any water that may be left over
from the test, run the first wash cycle
without any laundry.
Notes
The washing machine must be
■
correctly installed and connected.
(from ~ Page 34)
Never use a damaged machine.
■
Inform the after-sales service.
Preparatory work:
Check the machine.
1.
Fill the dispenser ß and i.
2.
~ Page 20
Remove the protective film from the
3.
control panel.
Plug into the mains.
4.
Turn on the tap.
5.
Run the programme without laundry.
Switch on the appliance.
1.
Close the door (do not load any
2.
laundry).
Set the Drum Clean 90 °C
3.
programme.
Positioning and connecting
Open the detergent drawer.
4.
Pour approx. 1 litre of water into the
5.
left-hand compartment.
Pour standard detergent into the left-
6.
hand compartment .
To prevent foaming, only use
Note:
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergents
designed for woollens or delicates.
Close the detergent drawer.
7.
Start the programme.
8.
Switch off the appliance at the end of
9.
the programme.
Your washing machine is now ready to
use.

Transportation

E.g. when moving house
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers.
Leaking detergent/fabric softener can
prevent the appliance from working
correctly, e.g. due to damage to the
electronics.
Empty the dispensers before
transporting the appliance.
Preparatory work:
Turn off the tap.
1.
Reduce the water pressure in the
2.
supply hose: ~ Page 28; cleaning
and maintenance – filter in the water
supply clogged
Disconnect the washing machine
3.
from the mains.
Drain any residual water:
4.
~ Page 27; cleaning and
maintenance – drain pump blocked,
emergency draining
Remove the hoses.
5.
Empty the dispensers. ~ Page 25
6.
en
39