Water Outlet - Bosch WAT28660GB Instruction Manual And Installation Instructions

Only tighten the screw connections
■
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may be
damaged.
Optimum water pressure in the supply
network
At least 100 kPa (1 bar)
Maximum 1000 kPa (10 bar)
When the tap is open, the water flow is
at least 8 l/min.
If the water pressure is higher than this,
a pressure-reducing valve must be
installed.
Connection
Connect the water supply hose to the
water tap (¾" = 26.4 mm) and to the
appliance (not necessary for Aqua-Stop
models as this is permanently installed):
Model: Standard
■
Model: Aqua­Secure
■
Model: Aqua-Stop
■
Positioning and connecting
Open the water tap carefully,
Note:
checking the leak tightness of the
connection points. The screw
connection is under mains water
pressure.

Water outlet

:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot water
(e.g. when draining hot water into a
washbasin).
Do not reach into the hot water.
Caution!
Water damage
If the drain hose slips out of the
washbasin or the connection point
during draining due to high water
pressure, any escaping water may
cause water damage.
Secure the drain hose so that it cannot
slip out.
Caution!
Damage to the appliance/fabrics
If the end of the drain hose is immersed
in the drained water, water may be
sucked back into the appliance and
may damage the appliance/fabrics.
Make sure that:
The plug does not block drainage
■
from the washbasin.
The end of the drain hose is not
■
immersed in the drained water.
The water drains away quickly
■
enough.
Do not kink the water drain hose
Note:
or put strain on it lengthways.
Connection
Drainage into a washbasin
■
en
37