Invacare Solara 3G User Manual page 113

Adjusting Lower Tilt Locking Collar
 This procedure limits the amount of tilt the
wheelchair may have. If adjusting the angle the
wheelchair returns to. Refer to Adjusting Upper
Tilt Locking Collar. on page 111.
1. Loosen the set screw that secures the tilt locking collar to the tilt
slide (Detail "A").
2. Repeat STEP 1 for opposite side of wheelchair.
To determine tilt angle relative to the seat frame,

place a magnetic protractor (available at any
hardware store) on the back and adjust the back
until the magnetic protractor reads desired angle
of tilt.
3. Tilt the wheelchair to the desired angle of tilt.
4. Position the two tilt locking collars against the bearing housing.
 Before tightening, ensure that the two tilt locking
collars are at the same position on the tilt slide.
5. Securely tighten the two set screws of the tilt locking collars (Detail
"A").
Part No 1154295
DETAIL "A"
Tilt Slide
Lower Tilt
Locking Collar
FIGURE 4 Adjusting Lower Tilt Locking Collar
113
Invacare® Solara®3G/Spree 3G Wheelchair
13 TILT
Bearing
Housing
Set
Screw