Installing/Replacing Chest Positioning Straps; Installing And Removing A Seating System - Invacare Solara 3G User Manual

12 BACK/SEAT

12.6 Installing/Replacing Chest Positioning Straps

Installing
1. Position the chest positioning strap to one of the holes on the back
cane.
 The standard recommended position for the chest
positioning strap is in the top hole of the back cane,
but may be mounted according to the user's needs.
2. Secure the chest positioning strap to the back canes with the new/
existing hex screw and locknut.
3. Repeat STEPS 1-2 for opposite side.
Replacing
1. Remove the hex screw that secures the chest positioning strap to
the back cane.
2. Discard existing chest positioning strap.
3. Repeat STEPS 1-2 for opposite side, if necessary.
4. Install the NEW chest positioning strap. Refer to Installing/Replacing Chest Positioning Straps on page 106.

12.7 Installing and Removing a Seating System

WARNING
Transport ready option only - This wheelchair has been tested for seating in a motor vehicle with the factory installed
seating system only.
1. Ensure that the seating system is compatible with this wheelchair.
2. Refer to the seating system Owner's Manual for installation and removal.
Invacare® Solara®3G/Spree 3G Wheelchair
Hex Screw
Chest Positioning Strap
FIGURE 8 Installing/Replacing Chest Positioning Straps
106
Back Cane
Locknut
Part No 1154295