Troubleshooting - Zanussi ZOP38903XD User Manual

The back lamp
1. Turn the lamp glass cover counterclockwise
to remove it.
2. Clean the glass cover.

Troubleshooting

WARNING!
Refer to Safety chapters.
What to do if...
Problem
You cannot activate or operate
the oven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The oven does not heat up. The
fan does not operate. The display
shows or .
The display shows an error code
that is not in this table.
22
3. Replace the lamp with a suitable 300 °C
4. Install the glass cover.
Possible cause
The oven is not connected to an
electrical supply or it is connec-
ted incorrectly.
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The automatic switch-off is acti-
vated.
The Child Lock is on.
The fuse is blown.
The lamp is defective.
The demo mode is activated.
There is an electrical fault.
heat-resistant lamp.
Check if the oven is correctly
connected to the electrical sup-
ply (refer to the connection dia-
gram if available).
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Refer to "Automatic switch-off".
Refer to "Using the Child Lock".
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Replace the lamp.
1. Deactivate the oven.
2. Press and hold
appliance activates and re-
turn to the standby mode.
3. Press and hold
the same time until the
acoustic signal sounds again
and the indicator goes out.
• Deactivate the oven with the
house fuse or the safety
switch in the fuse box and ac-
tivate it again.
• If the display shows the error
code again, contact the Cus-
tomer Care Department.
Remedy
until the
and at
www.zanussi.com