Zanussi ZOP38903XD User Manual page 20

CAUTION!
If there are other appliances installed
in the same cabinet, do not use
them at the same time as the
Pyrolysis function. It can cause
damage to the appliance.
To remind you that the Pyrolysis is
necessary, PYRO flashes in the
display for 15 seconds after each
activation and deactivation of the
oven. For as long as no complete
cleaning function is carried out,
cleaning reminders come on in the
display each time the oven is
activated or deactivated.
1. Remove the worst dirt manually.
2. Press again and again until the display
shows .
• The display shows P1 and
the other.
• An acoustic signal sounds as a reminder
to remove all accessories and shelf
supports from the appliance.
• The clock display shows 1:30.
• Duration flashes.
3. When flashes, press
necessary procedure:
Option
P1
P2
4. Press to start the procedure.
The bars on the symbol
to show that the temperature in the appliance
increases.
The symbol flashes.
After some minutes the door locks. The display
shows the symbol
20
one after
or to set the
Description
If the oven is not
very dirty. Time
of the proce-
dure: 1 h 30 min.
If the oven is
more dirty. Time
of the proce-
dure: 2 h 30 min.
come on one by one
.
To stop the cleaning procedure
before it is completed, press
When Pyrolysis is completed, the display shows
the time of day. The oven door stays locked.
When the appliance is cool again, an acoustic
signal sounds and the door unlocks.
Setting the End Time for the Pyrolysis
You can use the End
start of the pyrolytic cleaning procedure.
1. Start the Pyrolysis function.
2. Press again and again until the symbol
flashes.
The display shows the time for the end of the
Pyrolysis.
3. Press or to adjust the time for the
end of the Pyrolysis.
Cleaning the oven door
The oven door has four glass panels. You can
remove the oven door and the internal glass
panels to clean them.
The oven door can close if you try to
remove the glass panels before you
remove the oven door.
CAUTION!
Do not use the appliance without the
glass panels.
Open the door fully
1
and hold the two
door hinges.
.
function to delay the
Lift and turn the
2
levers on the two
hinges.
www.zanussi.com